Re: Consolidated Halo Topic

Quote from: Rigwald on Today at 11:55:23 AMHahaha, I just went to do mine.  I was going to start being doing halfway between your numbers and the starting numbers, just to see how it went.  I measured the current diameters, by taking the bits and fitting them into the orifice opening.  You know what I found?  Your numbers are actually the starting numbers.  My orifaces are 53 and 51! 
I don’t suppose you could measure your current orifices like I did? 

My drill bits are on loan to son, probably never see them again. He has my chop saw, favorite screwdriver, etc.  (https://woodfiredovens.online/wp-content/uploads/2024/07/localimages/smiley.gif6699e248e2173.gif)

Either my notes are bad, which is possible or the differences in tolerances between bits and orifi…